Chapter 9 Remote Connection Service
9-5
(5) IP address
Specify the IP address of FEnet I/F module installed in the PLC which will be connected with
XG5000 in the network 1. Use the IP address of FEnet module installed in PLC #2 station,
192.168.91.189
in [Fig. 9.2.3].
(6) Slot
It indicates the slot number where FEnet module is installed in locally connected PLC via
RS-232C. Select No.0 in [Fig. 9.2.3] since FEnet installed on PLC #1 is on slot No.0.
Now click [OK] and then select [Connect] on the Online menu.
Since stage 1 connection-completed status is the logical connection status identical to the
local connection with RS-232C cable is connected to the PLC, where all of the on-line menus
are available. (Except that CPU type between PLC and presently open project is
disagreeable)
1) Precautions for remote connection
Prepare a program suitable for the correspondent CPU type to connect with remotely
CPU type is disagreeable between the two, limited functions only will be allowed, where program
uploading/downloading and monitoring are not available.
To Next Page
Loading...
