EasyManua.ls Logo

Lubing LC-2 - Faults with pumps with belt-drive; Faults high-pressure valves;electric pressure relief

Lubing LC-2
58 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Top climate system
with LUBING Touch Controller
Copyright © Lubing System - All rights reserved
42
FAULT CAUSE REMEDY
Pump does not reach sufcient
pressure
• Too much slippage of the belt • Tension or replace belt
Excessive heating of the pulleys/
the pump
• The condition of the belt and/or
the pulleys is not okay.
• Tension of the belt
• Motor and pump shaft not
correctly aligned
• Replace belt and/or pulley
• Correct belt tension
• Align motor and pump shaft
parallel, belt pulleys must be in
alignment
FAULT CAUSE REMEDY
Valve does not open • Solenoid of high pressure valve is
too hot
• Solenoid of high-pressure valve
defective
• Voltage too low
• Power supply faulty
• Valve blocked by deposits
• The top of the high-pressure valve
was mounted rotated by 180°
(the relief bore in the housing and
cover must be aligned)
• Ensure adequate ventilation and
ventilation
• Replace solenoid
• Check voltage and increase if
necessary
• Repair electrical system
• Replace or clean valve
• Mount top correctly
Valve does not close while
pump is running
• Seals in the valve worn out
• Valve seat damaged in housing or
top
• Valve installed upside down (arrow
must point in direction of ow)
• Broken spring
• Bores clogged / deposits in valve
• Power supply faulty
• Replace valve
• Replace valve
• Install the valve correctly
• Replace valve
• Clean holes/valve or replace valve
• Repair electrical system
Leakage at the valve • Seals worn or damaged
• Parts of the valve damaged
• Valve incorrectly mounted
• Replace valve
• Replace valve
• Install the valve correctly
Large amount of water during
each pressure relief process
• Compressed air pushes the water
out of the pipes
• Main valve does not close properly
(permanent pressure at pressure
gauge behind main valve)
• Vent lines
• Check membrane and valve seats
of main valve; clean or replace
membrane/main valve
7.5 Faults high-pressure valves/electric pressure relief
7.4 Faults with pumps with belt-drive
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
c
om
l
ubin
g
s
y
stem.c
om
lub
i
n
g
s
y
stem.c
om
lubin
g
s
y
stem.
com
l
ub
i
n
g
s
y
stem.c
om
lub
i
n
g
s
y
stem.co
m
lub
i
ngsystem.co
m
l
ub
i
ngsystem.
com
l
ub
i
ngsystem.c
om
lubingsystem.com
lubingsystem.com

Table of Contents