Top climate system
with LUBING Touch Controller
Copyright © Lubing System - All rights reserved
9
with good professional practice is considered to be misuse. The manufacturer/supplier is not liable for any resulting
damage. The risk is borne solely by the user.
Intended use also includes:
– heeding all information from the operators manual,
– complying with the inspection and maintenance intervals,
– complying with the operating and maintenance conditions,
– taking foreseeable misconduct into consideration.
It is necessary to comply with the technical specications in chapter 8 “Technical data“ without exception.
The system is not allowed to be converted or otherwise altered without prior written permission from LUBING
SYSTEM SRL.
Any breach of this causes the system to lose its EC conformity. Such a breach absolves the manufacturer of the
machine from warranty. Any parts not in a perfect state must be replaced immediately. Parts and special features
not delivered by LUBING SYSTEM SRL are not released for use with the system.
2.5 Hazards due to electricity
2.6 Further hazards
IMPORTANT INFORMATION
Only use the system as intended; otherwise there is no guarantee of safe and reliable operation.
It is not the manufacturer but the plant operator who is responsible for any and all personal injuries and
material damage resulting from unintended use
DANGER!
Warning of electrical hazard!
Touching live parts or parts that have become live due faults, poses a direct risk of death. Damage to the
insulation or individual parts can be fatal hazard. Short-circuits and overloading pose the risk of being hit
by ejected molten parts.
– Always keep the control cabinet and all electricity supply units locked. Access is only allowed for
authorized persons with a key or special tool.
– Always run the controller with the correct electrical voltage.
– Only electrical specialists are allowed to work on the controller’s electrical equipment.
– Regularly inspect the controller’s electrical equipment for defects such as loose connections or
damaged insulation.
– If there is a damage, switch off the power supply immediately and have the damage repaired.
– When working in the electrical equipment always shut off the power and verify safe isolation.
– Switch off the power supply during maintenance, cleaning and repair work and prevent unexpected
restoration on power.
– Never bypass fuses or take them out of operation. When replacing fuses, pay attention to the
correct amperage.
– Keep moisture away from live parts as it can cause short-circuits. Never clean the electrical
equipment with water or similar liquids.
– Have the electrical equipment and xed electrical apparatuses tested by an electrical specialist
every four years at least.
– Alterations made after testing must comply with DIN EN 60204-1.
– Observe the regulations of VDE (Verband der Elektrotechnik Elektronik Informationstechnik e.V.)
or IEC (International Electronical Commission) and the national accident prevention regulations for
electrical systems and equipment.
WARNING
Injury hazard from hydraulics/pneumatics!
Work on hydraulic equipment may only be done by qualied personnel. All lines, hoses and ttings must
be properly installed and checked regularly for leaks and externally visible damage. Damage must be
repaired immediately. Splashing liquids can lead to injuries.
Before starting repair work depressurize system sections and pressure lines to be opened. Secure the
system against being switched on again.
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
lubingsystem.com
c
lubingsystem.com
lubingsystem.com
To Next Page
Loading...