Lubing LC-2 - SAFETY; General safety information; Safety measures before startup; Safety measures during normal operation

To Next Page

To Previous Page

Top climate system

with LUBING Touch Controller

2. SAFETY

The following safety information must be read carefully before working on the system and must be heeded. It

concerns your safety and is intended to prevent hazards and/or injuries.

2.1 General safety information

The following general safety information has to be observed:

– always read and understand the operators manual before operating the system;

– only use the system for its intended purpose (see chapter 2.4 “Intended use“);

– never operate the system without associated guards and safety devices. Never take tted safety devices out

of operation;

– always keep the work area around the system clean and tidy to prevent hazards due to dirt and things lying

around;

– do not exceed the technical data (see chapter 8 “Technical data”);

– only trained personnel are allowed to operate or work on the system;

– do not start the system if other persons are in the danger zone;

– take the system out of operation immediately if a fault occurs. Have faults rectied by appropriately qualied

personnel;

– always keep the operators manual at the place where the system is used. It must be ensured that all persons

dealing with the system are able to view the operators manual at any time.

2.2 Safety measures before startup

Familiarize yourself with the systems‘s:

– operating and control elements,

– features,

– working principles,

– immediate environment,

– safety devices,

– measures for an emergency.

Carry out the following activities before every startup:

– inspect the system for visible damage; rectify any detected defects immediately or report them to the

supervisory staff – the system must only be operated in a perfect condition.

– remove all objects and other materials that are not needed to operate the system out of its work area.

2.3 Safety measures during normal operation

Carry out the following inspection activities every day:

– inspect the system for externally visible damage.

– also pay attention to the instructions and information in or concerning the higher-level operating manual or

control systems.

2.4 Intended use

The safety of the system is only ensured if it is used as intended. The system is made for cooling and humidifying

the air inside a building. Other applications are described in chapter 1.1.

The system is not intended for another use than as described here; other use counts as inappropriate, e.g.

pumping liquids other than water. Treatment with aggressive/corrosive substances which are not in accordance

WARNING

Failure to observe the safety information below may have serious consequences:

– risk to persons due to electrical, mechanical or chemical effects,

– failure of important functions of the system.

Read the safety and hazard information in this section thoroughly before putting the system into operation.

In addition to the information specied in this manual always comply with general safety and accident

prevention regulations.

In addition to the information specied in this manual the plant operator/machine operator must comply with

national occupational, health and safety regulations. It is also important to follow internal rules and regulations.

lubingsystem.com

ubin

stem.c

lub

stem.c

lubin

stem.

com

stem.c

lub

stem.co

lub

ngsystem.co

ngsystem.

com

ngsystem.c

lubingsystem.com

Main Page

Lubing LC-2 - SAFETY; General safety information; Safety measures before startup; Safety measures during normal operation

Table of Contents