Lucent Technologies Lineage
®
2000 50A -48V 364A-3 SR Series Rectifier
Issue 6 January 1997 Safety 4 - 1
4 Safety
Safety
Statements
Please read and follow all safety instructions and warnings
before installing, maintaining, or repairing the 364A3 rectifier
and the J85702B-2 RSA (rectifier shelf assembly).
The 364A3 and J85702B-2 were Recognized by Underwriters
Laboratories Inc. to the requirements of UL 1950 Information
Technology Equipment. Recognition is based on the items noted
below:
1. The output voltage is a hazardous energy level Extra Low
Voltage (ELV) as defined by UL 1950.
2. The 364A3 is evaluated as a component rectifier for use
only in a shelf that provides mating connectors for the
input and output terminals of the rectifier, e.g., J85702B-2
RSA. The input and output terminals of the rectifier are not
intended for direct connection of field wiring conductors.
Field wiring connections are made inside the RSA.
3. Install the 364A3 rectifier only in restricted access areas
(dedicated equipment rooms, equipment closets, etc.) in
accordance with articles 110-16, 110-17, and 110-18 of the
U.S. National Electric Code (NEC), ANSI/NFPA No. 70,
and pursuant to applicable local codes. In addition, this
rectifier may be installed as a component to other
equipment where the acceptability of the combination has
been evaluated by Underwriters Laboratories Inc.
4. This equipment is to be used in controlled environments
(an area where the humidity is maintained at levels that can
not cause condensation on the equipment, the
contaminating dust is controlled, and the steady-state
ambient temperature is within the range specified).
To Next Page
Loading...
Need help?
General