Page 16 of 60
Diagram 2.4-4
5. Place the screw into the bottom of the wheel base in the center. Attach the vertical tube to the wheel base
by tightening the screw using the 6mm allen key provided as show in diagram 2.4-5.
Diagram 2.4-5
6. Take the main cable connector coming out of the bottom hole on the vertical tube and connect it to the
bottom of the power box.
Diagram 2.4-6
NOTE: There is a bump on top of the red dot on the main cable connector. This bump will fit into the notch
located on the power box connector. Make sure to match the bump to the notch. The cable will plug in
easily. Do not force it in.
Diagram 2.4-7
7. The Camera Base Plate should already be attached to the bottom of the colposcope. If that is the case, skip
to step 10. If not, detach the camera base plate from the camera base mount by turning the knob located at
the top of the Camera Base Mount counterclockwise.
To Next Page
Loading...
