Why does 'Batt' indication flash on my Lutz ST?
The 'Batt' indication might flash or remain permanently on because the battery service life has ended, the batteries are fitted incorrectly, or the battery contacts are corroded. To resolve this, replace the batteries, check the polarity of the batteries, or clean the battery contacts.
What to do if liquid leaks from the housing of Lutz Measuring Instruments?
If liquid leaks from the housing, it could be due to a defective seal, hairline cracks in the housing or screw connection, or a screw connection that isn't tightened securely. You should replace the seal, check the installation conditions for mechanical stresses and correct them, and ensure that screw connections are secure.
What to do if Lutz ST filling process is interrupted?
If the filling process is interrupted and 'STOP' appears on the display, it could be that the solenoid valve does not open or the time required to fill the connecting lines exceeds the set monitoring time. Check the solenoid valve. Also, consider increasing the monitoring time.
Why is the throughput decreasing in my Lutz ST Measuring Instruments?
A decrease in throughput may be due to inadequate chemical resistance, a soiled filter screen, or a soiled measuring chamber. Contact the manufacturer, remove and clean the filter screen, or regularly flush and clean the flow meter, especially after handling aggressive, tacky, crystallizing, or very contaminating liquids.
Why Lutz ST Measuring Instruments shows different quantity from the actual quantity?
If the measured quantity differs significantly from the actual quantity, it could be because the correction factor does not match operating conditions or the wrong unit of measure is set. Calibrate the flow meter or set the correct unit of measure.
How to fix no liquid registered by Lutz ST Measuring Instruments?
If no liquid is registered, it may be due to a correction factor of 0 in the main memory, leaks in the hose system, or dry running. Calibrate the flow meter, install a check valve if necessary, and prevent air pockets in connecting lines by using a solid hose system.
Explains potential dangers and user responsibilities for the flow meter system.
Details safety symbols used in the manual and their meanings.
Covers general usage guidelines and specific safety for explosion hazard areas.
Step-by-step instructions for connecting the flow meter for drum pump operation.
Guidance on connecting the flow meter to piping systems using flange connections.
Covers proper use, technical data, and electrical specifications for the operating unit.
Provides critical safety information for using the operating unit in potentially explosive environments.
Explains manual mode operations like resetting, displaying totalizer, and flow rate.
Instructions on entering filling volume, starting, and interrupting the filling process.
Details how to correct and stop the filling process, including volume adjustments.
Step-by-step guide for calibrating the flow meter by comparing displayed and actual volumes.
Provides the formula and steps for calculating a new correction factor in automatic mode.
Provides instructions for changing batteries, including safety precautions for hazardous areas.
Instructions for changing fuses in relay modules and mains units, including safety warnings.
Instructions for changing fuses in the Ex-RM1m module, including safety precautions.
General| Brand | Lutz |
|---|---|
| Model | ST |
| Category | Measuring Instruments |
| Language | English |
To Next Page