Lutz ST - Stopping the Filling Process; Repeating a Preselected Volume

GB
28
Operation Display
The entered filling volume flashes
+ The entered filling volume flashes The filling process can be started (see chapter C 3.2.3).
+ The correction process is only successful if the new filling volume is greater than the volume which has
already been transported.
3.2.6 Stopping filling process
Operation Display
+ It is possible to make a new input (see chapter C 3.2.2)
or to repeat the current filling volume using the RESET key (3).
Filling volume flashes
3.2.7 Repeating a preselected volume
Operation Display
C. Operating unit