GB
6
Table of Contents
3.2 Automatic mode 25
3.2.1 Switching between manual and automatic mode 25
3.2.2 Entering the filling volume 26
3.2.3 Starting the filling process 26
3.2.4 Interrupting the filling process 26
3.2.5 Correcting the filling process 27
3.2.6 Stopping the filling process 28
3.2.7 Repeating a preselected volume 28
3.2.8 Cycle counter 29
3.2.9 Filling with step-by-step interruption (SLOW mode) 29
3.2.9.1 Entering/deleting the SLOW volume 29
3.2.9.2 Displaying the SLOW volume 30
3.2.10 System protection through detection of faults 31
3.2.11 Locking function automatic mode 32
3.3 Calibration 32
3.3.1 Calibrating through comparative measurement 33
3.3.2 Changing the correction factor in the main memory 34
3.3.3 Displaying the correction factor from the main memory 34
3.3.4 Entering the correction factor into an addressable memory location 35
3.3.5 Displaying the correction factor from an addressable memory location 36
3.3.6 Copying the correction factor from the main memory into the
addressable memory location 36
3.3.7 Copying the correction factor from an addressable memory location
into the main memory 37
3.3.8 Calculating of the correction factor in automatic mode 38
3.4 Special functions 39
3.4.1 Changing the unit of measurement 39
3.4.1.1 Unit of measurement litres 39
3.4.1.2 Unit of measurement US-gallons 39
3.4.1.3 Unit of measurement IMP-gallons 39
3.4.1.4 Conversion of the flow volume in kilograms via the correction factor 40
Example 40
3.4.2 Deleting totalizer 41
3.4.3 Correcting operation errors 41
4. Maintenance and servicing 42
4.1 Changing the batteries 42
To Next Page
Loading...
Need help?
General