22
XMS-1024P
a: 14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | luxul.com | 801-822-5450
LUX-UG-XMS-1024P Vers: 081314
DST Config
Date Mode:
Allows you to specify the DST configuration using a Date format instead of
a week, day and month format. This configuration will not run in a recurring
mode and must be set each year.
Offset: Specifies the change of time in minutes when a DST event occurs.
Start Time/End Time: Set the Starting and Ending dates for DST in your
geographical location.
NOTE: The DST settings will be restored to defaults if the Switch is restarted
and you have not selected Save Config from the main menu and
saved your running configuration to
non-volatile memory.
NOTE: When DST is disabled the various modes cannot be configured.
NOTE: When DST is enabled the default daylight savings time will be set to
USA in predefined mode.
4.1.5 System IP
Each device in an IP Network must have a unique IP Address. You log in to the Web
Management page of the Switch using the Switches IP Address. The Switch supports
three modes to set the IP Address: Static IP, DHCP and BOOTP. The IP Address set using
the new mode selected will replace the current IP Address. On this page you can config-
ure the system IP of the Switch.
Choose the menu System>>System Settings>>System IP to load the following page.
To Next Page
Loading...
Need help?
General
