LX Navigation LX10K - Load Task; Flarm NET

LX 10k
Device setup
Document name: LX 10KUM
Document revision: R1
5.2.5.3 Airspace
Airspace files, in the .cub file format, can be found on both the
LX navigation database part of webpage, as well as supplied by competition directors,
club managers, club mates and other readily available database sources.
In order to use a certain airspace file, first you need to copy it to the LX 10k’s internal memory,
through the Load sub-menu, and then select it as active through the Select sub-menu. Multiple
airspace files can be selected at once.
NOTE
The LX 10k requires airspace files in the .cub file format.
5.2.5.4 Load task
Task files are stored into the .cup file usually, and consequently the same rules apply as for the
turnpoint files.
Once opened, the Load task sub-menu will show all .cup files with internal tasks. You can
select the desired turnpoint file and a selection of tasks saved to this file will be found.
Choosing the task will set the selected task as the current active task.
NOTE
The LX 10k is capable of sending task declarations to external devices (the MOP,
Flarm, etc.). This happens when one of the following conditions is met:
• The LX 10k receives a task from an external device through the User port
• The LX 10k receives a task from an external device through Bluetooth
• The LX 10k receives a task from a .cup file through the Load task menu
• Whenever we exit the task edit page in the Task navigation page.
NOTE
The LX 10k requires task files in the .cup file format.
5.2.5.5 Flarm NET
The LX 10k allows the utilization of Flarm NET databases. If a database is used, and a Flarm
object with a Flarm ID found in the database shows up, the LX 10k will automatically use the
info from the FlarmNET database and assign it to the said object.
Device manual Public 72