LX 10k
Device setup
Document name: LX 10KUM
Document revision: R1
5.2.6 Network
This part of the manual will only go through the settings available in the Network sub-menu
part. For information on how to connect to different devices and utilize the LX 10k’s connectiv-
ity capabilities, please check the Connectivity section of this manual.
The LX 10k has a single module used for both Wifi and Bluetooth. The module has five different
available states:
• Off - no connectivity options are available
• Bluetooth server - is used for transmitting data to an external device - like an Android
phone or PDA/PNA device. The external device needs to connect to the LX 10k in order
to establish communication.
– The wireless setup will show the device name and password.
• Bluetooth client - is currently not available for use. Once enabled, will give the LX 10k the
possibility to connect to an external Bluetooth device.
– The wireless setup will show a list of available devices for connection.
• WiFi Access point - is currently not in use. Once enabled, will give the LX 10k the possibility
to stream data through the WiFi network.
– The wireless setup will show the device information and offer the user to change
WiFi name and password of the LX 10k’s WiFi.
• WiFi Client - is used for connecting an LX 10k to a WiFi network. Once connected, the LX
10k is able to communicate with the world wide web and send flights via emails.
– The wireless setup will show a list of available devices for connection.
This setup also includes the email setup page. Once opened, you are presented with a set of
email-related options.
You can create and activate multiple emails at once. When a flight is chosen for sending over
the email in the Logbook/Flight statistics page, it will be sent to all active emails.
When connecting to a device, either through Bluetooth, or WiFi, an icon to the right of the
device names is shown. This icon shows what is the state of the device connection, or it’s
signal strength.
• Strong signal -
• Medium signal -
• Weak signal -
• Connecting -
• Password required for network -
In general, all available devices are shown under the ’Available list’. If the LX 10k is connected
to a device, it will be shown under the ’Connected’ list.
Device manual Public 73
To Next Page
Loading...
