LX 10k
Vario Indicator Unit
Document name: LX 10KUM
Document revision: R1
7.1.3.2 Thermal assistant
This menu holds additional settings for the thermal assistant page for the digital variometer.
The setup options for the thermal assistant page is the same as described previously for the
main unit.
• Auto TA - Ticking this option will make the Era turn to TA page when it detects circling
has started. Once the Era detects it is no longer circling, it will revert back to the page you
had before.
• MC color - When MC color scheme is ticked, red dots represent climb which is stronger
than 1.2*MC value set. Yellow dots represent climb in range of 0.8*MC and 1.2*MC value
set. Blue dots represent climb less than 0.8*MC value. If MC setting is less than 0.5m/s,
default color scheme is used.
• Max beep - The device beeps when you are passing through the point at which the maxi-
mum thermal strength was recorded in your last turn.
• Beep offset - Offsets the beep by a set amount of seconds.
7.1.3.3 Service
The Service setup page contains various device and service related settings, as noted below:
• Device info - shows basic information regarding the Era:
– Serial number
– IGC number
– Firmware version
– Build
– Hardware version
– Battery - voltage of internal battery
• CAN unit Info - shows a list of all device on the CAN line, with their appropriate software
and hardware versions.
• Password - opens up the dialog for admin passwords, like the one for Club mode
The following passwords are at the pilot’s disposal:
• 46486 - Deletes all internal files (database files, pilot information, etc.) Can be considered
as reverting the device to factory settings.
7.1.3.4 Shutdown
Performs the shutdown sequence for the device.
Device manual Public 92
To Next Page
Loading...
