MacDon A30-D - Step 8. Remove Shipping Channels and Blocking

UNLOADING AND ASSEMBLY
169001 Revision E
14
STEP 8. REMOVE SHIPPING
CHANNELS AND
BLOCKING
a. Remove bolts (A) and (B), and remove banded
link and arm (C) from shipping channel (D) at
each float spring mount. Retain bolts (A) and (B)
for re-installation.
b. Remove bolts (E), and remove shipping channel
(D). Discard.
c. Remove banding, and remove the two shipping
angles (F). Discard.
CAUTION
Keep feet clear when removing banding.
d. Remove banding at ends of shipping beam, and
let beam fall to ground.
e. Remove banding at center-link location.
f. Loosen float springs by turning bolts (H)
counterclockwise on both sides of frame, so that
blocks (G) can be removed.
F
D
A
C
B
E
G
H