Chapter 4
HARDWARE COMMANDS
4.1 AT#SERIAL
Configure the user-side UART baudrate, character-framing and flow control
ALLOWED: exec-state-info
Note:
– Bauds 300, 600 are not supported
– The character-framing of 7 data-bytes does work with current configuration, but unreliably.
AT#SERIAL=(baud),(charFraming),(flowCtrl)
– baud: one of (1200,2400,4800,9600,19200,38400,57600,115200)
– charFraming: one of ("8N1","8N2","9O1","9E1"). See also note above.
– flowCtrl
• 0: disable
• 1: enable
exec :
AT#SERIAL=115200,"8N1",0
OK
state :
AT#SERIAL?
#SERIAL: 115200,"8N1",0
OK
info :
AT#SERIAL=?
#SERIAL: (1200,2400,4800,9600,19200,38400,57600,115200),("8N1","8N2","9O1","9E1"),(0-1)
OK
4.2 AT#HFLW
Enable or disable hardware flow control
ALLOWED: exec-state
Confidential, the whole document is the sole property of Maestro Wireless Solutions Ltd.
Please contact us on support.maestro-wireless.com
17
To Next Page
Loading...
