Chapter 8
DOTA COMMANDS
8.1 AT#WEBUPDATE
Command to congfigure DOTA parameter & initiate HTTP DOTA for firmware update
ALLOWED: exec-state-info
Note:
– If only the filename is given, default IP and port are "updates.d2sphere.com" and 80 respectively
– If the filename is correct, the download starts immediately.
AT#WEBUPDATE=(filename)[,(port),(ip)]
– filename: up to 120 characters, in quotes
– port: port of the server on which the update file is stored (the default value is set by Maestro, see note above)
– ip: IP address of the server on which the update file is stored (the default value is set by Maestro, see note
above)
exec :
AT#WEBUPDATE="/mpack/mpack_R0100.bin",80,"3.252.19.23"
OK
state :
AT#WEBUPDATE?
#WEBUPDATE: "/mpack/mpack_R0100.bin",80,"3.252.19.23"
OK
info :
AT#WEBUPDATE=?
#WEBUPDATE: (120),(0-65535),(120)
OK
8.2 AT#UPDATE
Controls the update process
ALLOWED: exec-state
AT#UPDATE=(value)
Confidential, the whole document is the sole property of Maestro Wireless Solutions Ltd.
Please contact us on support.maestro-wireless.com
39
To Next Page
Loading...
