7. In case the modem cannot get terminal Read Response within 26 seconds, the modem will then abort the
command, and return intermediate Read Responses (if present).
8. If the SMSAT feature is enabled, all incoming SMS, either with valid AT command or not, will be erased. This is
to prevent SIM card memory from fully filled; such the modem will not receive new SMS.
Configure, enable and disable remote AT command by SMS
ALLOWED: exec-state-info
AT#SMSAT=(mode)[,(param)]
– mode
• 0: Disable SMSAT
• 1: Enable SMSAT
• 2: Change the password for SMSAT
• 3: Change the SMS response trigger
– param
• for mode=2 : password, 6 characters in quotes (quotes optional if password is purely numeric)
• for mode=3 : 0 to disable SMS response; 1 to enable SMS response
• (not needed for modes = 0 or 1)
exec :
AT#SMSAT=2,123456
OK
state :
AT#SMSAT?
#SMSAT: 0,"123456",0
OK
info :
AT#SMSAT=?
#SMSAT: #SMSAT: (0-2),((6)/(0-2))
OK
7.2 AT#TCPTERM
Parameter configuration for enabling configuration over cellular data network; and start/stop TCP Terminal for
remote commands over TCP.
ALLOWED: exec-state-info
Note:
– Network watchdog ping is used by application when the device enters data mode
AT#IPTCP=(idx),(port),(mode),(ip)[,(delay)]
36 Confidential, the whole document is the sole property of Maestro Wireless Solutions Ltd.
Please contact us on support.maestro-wireless.com
To Next Page
Loading...
