6.2 AT#IPUDP
Command to set UDP socket parameters
ALLOWED: exec-state-info
Note:
– Mode & IP address should be entered in quotes
– Currently only the "client" mode has been implemented
– The "delay" parameter is deprecated and has no effect (suggested not to use)
AT#IPUDP=(idx),(port),(mode),(ip)[,(delay)]
– idx
• 1: UART port of modem
• 2: USB port of modem
– port: number from 0 to 65535
– mode
• "C": Modem to connect to remote UDP server
• "S": Modem waiting for remote UDP client to connect
– ip: IP address of remote partner (IPv4 dotted notation)
– delay: delay: (deprecated, no need to enter)
exec :
AT#IPUDP=1,50003,"C","162.242.170.47"
OK
exec :
AT#IPUDP?
#IPUDP: 1,50003,”C”,"162.242.170.47",1
#IPUDP: 2,0,”C”,"",1
OK
exec :
AT#IPUDP=?
#IPUDP: (1-2),(0-65535),("C","S"),(120),(0,1)
OK
6.3 AT#AUTOTCP
Command to Start Auto TCP functionality
ALLOWED: exec-state-info
AT#AUTOTCP=(mode)
– mode
28 Confidential, the whole document is the sole property of Maestro Wireless Solutions Ltd.
Please contact us on support.maestro-wireless.com
To Next Page
Loading...
