Maestro M111 - 11 Application Notes; Cellular Setup Example; Autotcp Client Setup Example

Chapter 11
APPLICATION NOTES
11.1 Cellular Setup Example
The AT#IPCELLULAR command is used to setup cellular network parameters. The configuration of the cellular
network is done by setting the following parameters:
AT#IPCELLULAR=<SIM>,”<APN>”,”<Username>”,”<Password>”
where:
– SIM : 1 for bottom SIM, 2 for top SIM. Use 1 for mono-SIM models
– APN : Access Point Name
– Username : If omitted, the modem will supply a non-blank value when it is read
– Password : If omitted, the modem will supply a non-blank value when it is read
Examples:
Command Response Description
AT#IPCELLULAR=1,<APN>,"a","a" OK This command is used to set the
cellular/data network by
configuring the sim slot, APN,
Username and Password
AT#IPCELLULAR? #IPCELLULAR: SIM1:
"internet","*","*",8
OK
This commands reads what is the
current setting
AT#IPCELLULAR? #IPCELLULAR:
(1),(64),(25),(25),[(1-11)]
OK
The command is used to give the
valid range of all parameters
11.2 AutoTCP Client Setup Example
Note-1: AutoTCP should be disabled before changing any AT#IPCELLULAR and AT#IPTCP parameters
Note-2: AT#IPCELLULAR parameters must be set up correctly before AutoTCP can be used.
The AT#IPTCP command is used to setup TCP Client socket parameters:
AT#IPTCP=<UART/USB>,”<IP-port>”,”<Client/Socket>”,”<IP-address>”
where:
– UART/USB : 1 for UART; 2 for USB
– IP-port : port of the TCP Socket Server
– Client/Socket : Use "C" for modem as TCP client
Confidential, the whole document is the sole property of Maestro Wireless Solutions Ltd.
Please contact us on support.maestro-wireless.com
47