Maestro M111 - Cellular Commands; AT#IPCELLULAR; AT#IPCONNECT

Chapter 5
CELLULAR COMMANDS
5.1 AT#IPCELLULAR
Configure cellular parameters for both the SIM slots: APN, username and password.
ALLOWED: exec-state-info
AT#IPTCP=(idx),(port),(mode),(ip)[,(delay)]
– slot: SIM slot (NOTE: slot 2 is only available on selected models)
– APN : Access Point Name
– username : username for cellular data access. If no username is needed, can omit the argument and mPack
software will use a non-null but meaningless value when state is read
– password : password for cellular data access. If no password is needed, can omit the argument and mPack
software will use a non-null but meaningless value when state is read
– CID : context ID. Please consult Maestro team on when to use this parameter and what value to use
exec :
AT#IPCELLULAR=1,"CMHK"
OK
state :
AT#IPCELLULAR?
#IPCELLULAR: 1,"internet","*","*",8
OK
info :
AT#IPCELLULAR=?
#IPCELLULAR: (1),(64),(25),(25),[(1-11)]
OK
5.2 AT#IPCONNECT
The 1st parameter in this command is only for format correspondence with the older SmartPack version
ALLOWED: exec-state-info
Note:
– The 1st parameter in this command is only for format correspondence with the older SmartPack version.
Confidential, the whole document is the sole property of Maestro Wireless Solutions Ltd.
Please contact us on support.maestro-wireless.com
23