5-172 Magellan
TM
2200VS/2200VS and 2300HS/2300HS
Keyboard Interface — Keyboard Layout — continued
Remember to cover any unused bar codes on this and the facing page to
ensure that the scanner reads only the bar code you intend to scan.
KEYBOARD LAYOUT = POLAND
Keyboard Interface Quiet Interval
Specifies amount of time to look for keyboard activity before scanner
breaks keyboard connection in order to transmit data to host.
To set the Keyboard Interface Quiet Interval:
1. Scan the SWITCH bar code.
2. Scan the bar code below,
SET KEYBOARD INTERFACE QUIET
INTERVAL
. You’ll need to cover any unused bar codes on this and
the facing page to ensure that the scanner reads only the bar code
you intend to scan.
3. Scan the appropriate digits from the keypad in
Appendix C that rep-
resent the desired delay. The selectable range is 1-100, which is the
interval duration in 10-millisecond increments. Pad all single and
double digit numbers with leading zeroes to yield a three-digit entry
(001-100).
Examples:
001 = 10ms
005 = 50ms
040 = 400ms
100 = 1,000ms (1 second)
4. The scanner will automatically exit Programming Mode when the
appropriate amount of digits have been scanned.
SET KEYBOARD INTERFACE QUIET INTERVAL
To Next Page
Loading...
Need help?
General