Keyboard Wedge/USB Keyboard Features
Product Reference Guide 5-175
Keyboard Interface — Keyboard Simulation
Enables/disables ability of scanner to perform host communications nor-
mally performed by attached keyboard.
All PCs check the keyboard status during the power-on Selftest. It is rec-
ommended that you enable this function if you are working without a
keyboard installation. It simulates keyboard timing and passes the key-
board status to the PC during power-on.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover
any unused bar codes on this and the facing page to ensure that the
scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
KEYBOARD SIMULATION = DISABLE
KEYBOARD SIMULATION = ENABLE
NOTE
This feature does not apply to the USB Keyboard interface.
To Next Page
Loading...
Need help?
General