Operation and Maintenance
3-30 Magellan
TM
2200VS/2200VS and 2300HS/2300HS
Scanner Reset
As with any electronic equipment, it is sometimes necessary to reset the
electronics. The reset procedure allows you to initiate a reset command to
the scanner. This may be necessary if the POS terminal has been switched
off or the store system has been reset while the unit is on. Reset can also be
used to initiate and run the scanner’s internal Selftest routine.
Pressing and holding the Volume/Tone Push Button for approximately
eight seconds initiates a reset, which is sounded by a rapid number of
beeps. If the motor had been spinning, the lamps will blink while the
motor spins down. At that point, the motor will spin back up and the
scanner will continue to run the Selftest diagnostics. For more informa-
tion, see the topic,
Power-Up/Selftest & Pre-Operation, earlier in this
chapter.
Operational Maintenance
The scanner will provide dependable service for many years. The follow-
ing maintenance procedures will keep it operating at peak performance.
Cleaning
Clean the exterior surface of the scan window at least twice daily with a
nonabrasive, mild, water-based glass cleaner and paper towels or lint-free
cleaning tissues. Textured plastic surfaces and stainless steel can also be
cleaned using these cleaning agents.
To Next Page
Loading...
Need help?
General