Magicar M880AS - Calibration of the Function - Hazard Light Mode; Valet Mode; Entering Valet Mode Without a Pin Code

47
EN
EN
Programming menu RESET
In case you wish to set all the function back to the pre-set, you can do so by the following way. All the
functions will be set to option 1.
Procedure:
1. Turn the ignition on and open the door.
2. For resetting the programming menu No.1, keep buttons l+ll pressed for 2 seconds.
For resetting the programming menu No.2, keep buttons l+lV pressed for 2 seconds.
3. Lights will flash and siren will beep once.
4. Within 2 sec. press the button III. Lights will flash and siren will beep once.
Press button III again. Lights will flash and siren will beep once.
Press button III again. Lights will flash and siren will beep once.
5. After few seconds siren will beep 3 times and the lights will flash 3 times to confirm the reset of
the programming menu.
VIII. SEQUENTIAL CONTROL OF LIGHTS
In case it is not possible to control hazard lights directly for the alarm needs, you can use the
sequential mode. In this case the alarm, using the lights output, replaces a hazard light switch
(Fig.1). In the programming menu 2-06 you can set the continuous mode and the pulse mode.
It is possible connect directional light input CN4-8 to wire of directional light as feedback control if
sequential control mode is selected.
IX. VALET MODE
You can access the valet mode of the alarm system even without the remote control (in case of a
lost or damaged remote). You can enter valet mode without using a PIN code or with a PIN code
(Programming menu 1-10).
Entering valet mode without a pin code.
Armed. Open the door. The alarm will be triggered. Wait for 30 second until siren will mute.
Within 3 seconds repeat the following 3 steps:
1. Turn the key to the “Ignition On” position. When the ignition is on, the
lights on the dashboard will be turned on. In most vehicles, this position
is located two “clicks” forward from the “Off” position.
2. Turn the ignition off. The lights on the dashboard should be turned off.
3. Steps 1 and 2 must be repeated for a total of three times within three
seconds. Once this has been done, the alarm will be turned off and valet
mode will be activated.
Fig.1 Diagram of sequential control of lights with feedback control
outputs - lights
Lights - flashing
continuous
pulse
Hazard
Lights
Switch
Lights Control
Unit
Relay contact bypassing
the hazard light switch
Lights outputs (CN2-1 or 2)
Common input (CN1-6)
Directional light input CN4-8