2. Open the door.
3. Push the button on RPS sensor 10 times. At every single click, LED will flash red once.
Intervals between the click/pushes must not be longer than 1.5 sec.
4. Blue LED will start flashing rapidly. If it does not happen, go back to step 1.
5. Push the button on RPS as many times as your first number between 1-9 is. After each
push red LED will flash.
6. After entering the digits, wait until LED will confirm the number by a correspondent number
of blue LED flashes.
7. Blue LED will start flashing rapidly. Push the button on RPS as many times as your second
number between 1-9 is. At each push of the button red LED will flash once.
8. After entering the digits, wait until LED will confirm the number by a correspondent number
of blue LED flashes.
9. Continue by repeating steps 7, 8 for entering the third and fourth number of your code.
10. After entering the fourth number, lights will flash to confirm that the program code has been
accepted.
Changing PIN code
PIN code is set as the factory default code (11). PIN code must be inserted to enter Valet mode
after turning key on/off 3 times if you have already selected “PIN code ON” from optional table.
Procedures of change PIN code from the factory default code 11 to owner’s own code
1. System is disarmed.
2. Maintain the conditions of the trunk and the door being opened.
3. Turn the key on/off 3 times. Lights will flash once. Siren makes a long beep.
4. Push the button on RPS as many times, as your first number (1-9) is. Intervals between the
click/pushes must not be longer than 1.5 sec.
5. Siren beeps once. Lights will flash once.
6. Push the button on RPS as many times, as your second number (1-9) is.
7. Siren beeps twice. Lights will flash twice.
8. Press button IV on remote for authentication. Siren beeps three times and lights will flash
three times.
To Next Page
Loading...
