IMPULSE•T Instruction Manual – October 2015
5-22
Operator Parameters
The keypad parameters give the ability to show a variety of information such as frequency reference,
motor current, input and output terminal status, along with fault trace information. Information
displayed can be customized to meet your crane and hoist application. Below is a list of parameters
covered in this section.
• O2 Drive Selection
• U1 Monitor Parameters
• U2 Fault Trace
• U4 Maintenance
Drive Selection
Table 5-25:Drive Selection Parameter Settings
Parameter
Code
Name Function Range
Initial
Value
Access
Level
O2-04 kVA Selection Determines the model number of
the drive, which is based on the
kVA rating. The following in this
column are Magnetek model
numbers.
60–97 * Adv
60 -- Not used
61 -- Not used
62 2A0004 2004-T
63 2A0006 2006-T
64 -- Not used
65 2A0010 2010-T
66 2A0012 2012-T
67 -- Not used
68 -- Not used
91 4A0001 4001-T
92 4A0002 4002-T
93 4A0004 4004-T
94 4A0005 4005-T
95 -- Not used
96 4A0009 4009-T
97 -- Not used
*Initial value determined by drive model.
To Next Page
Loading...
Need help?
General