Mahindra '16' Series User Manual

16 Series, Model - 2816 4WD
Transmission Oil Change
Oil Change Interval ............................................................ Every 200 hours
To change the transmission oil, use
the following procedure:
1. Put the tractor on level ground,
apply the park brake and stop
the engine. Move the range shift
lever to L position.
2. Remove the drain plugs from the
transmission case.
NOTE: For best results, drain the
oil when the oil is warm.
3. Replace the hydraulic filter. See
Hydraulic Filter in this manual.
4. Install the drain plugs with a seal
washer and tighten to a torque of
39 to 44 Nm (29 to 33 lb ft).
5. Add the recommended oil
through the fill hole and check
the oil level.
6. Start the engine and check for
leaks.
7. Recheck the oil level after
stopping the engine. If the oil
level is low, add oil up to the
specified level.
DRAIN PLUGS
GEAR DRIVE
GEAR DRIVE
FILL HOLE
110
LUBRICATION/FILTERS/FLUIDS___________________________________________

Mahindra '16' Series Specifications

General

Engine Type	Diesel
No. of Reverse Gears	2
Drive Type	2WD
PTO RPM	540
Steering Type	Manual