16 Series, Model - 2816 4WD
HYDRAULIC FILTER
CHANGE THE HYDRAULIC FILTER AS FOLLOWS:
1. Put the tractor on level ground, move the range shift lever to the L
position
and apply the park brake.
2. Put an
oil canister under the hydraulic filter.
3. Turn the filter counterclockwise to remove. Use a filter wrench if
necessary.
4. Apply
clean oil to the O-ring on the new filter.
5. Install the filter. Turn the filter until the O-ring comes in contact with
the case surface. Tighten the filter an additional 2/3 turn by hand.
IMPORTANT: DO NOT use a filter wrench to install the hydraulic filter.
When the filter is too tight, you can cause damage to the O-ring and
filter.
6. Wipe around the hydraulic filter with a dry cloth.
7. Change the transmission oil. See Transmission Oil Change in this
manual.
NOTE: Replace the hydraulic filter
after the first 50 hours of operation
and every 200 hours of operation
thereafter. Your Dealer has ap-
proved genuine filters. Do not use
o
ther type filters.
Hydraulic Filter (Hydrostatic Drive)
Change Interval .................................................. Every 200 hours (See NOTE)
111
LUBRICATION/FILTERS/FLUIDS___________________________________________
To Next Page
Loading...
Need help?
General
