16 Series, Model - 2816 4WD
3. Do not use the starter motor for more than 10 seconds without
stopping. Wait one minute between starts so the starter motor can
cool.
4. If the engine stops when operating with a load, immediately start the
engine again to prevent overheating caused by stopping the flow of
oil for cooling and lubrication.
5. If the charge indicator comes on during operation, determine and
correct the cause to avoid complete discharge of the battery and
possible damage to other components of the electrical system. See
your Dealer.
6. If the coolant temperature indicator comes on, remove the load and
allow the engine to run at 1500 rpm until the indicator goes out. If the
indicator does not go out within one minute, stop the engine and
determine the cause.
47
OPERATING INSTRUCTIONS
____________________________________________
To Next Page
Loading...
Need help?
General
