Ó
ü
q p
Calibration Min Nominal value Calibration Max
-1.000 -0 1.000
Measurement Display Setup System
Customer calibration
Please set the probe at
Zero
and accept
Measurement Display Setup System
Absolute mode
Customer calibration
Factory calibration
Factory settings
Keyboard-/ menu interlock
Info
Ó
ü
q p
ü
– Connect the jumpers to the
Factory standard as illustrated
=> The following appears on the
display:
Set probe to “0” and accept
– Press ü to conrm
=> Factory standard calibration
according to the customer's
specication is complete and
activated
– Press the ON / OFF key to exit the
input menu.
To Next Page
Loading...
Need help?
General
