Table of Contents
1. Delivery and connection
1.1 Unpacking ......................................................................................... 8
1.2 Scope of delivery .............................................................................. 9
1.3 Symbols ....................................................................................... 10
1.4 Operating elements and interfaces ................................................. 12
1.4.1 Display and operating keys ............................................................. 12
1.4.2 Interfaces ....................................................................................... 12
1.4.3 Battery compartment ....................................................................... 13
2. Initial operation (basic conguration)
2.1 Switching ON .................................................................................. 14
2.2 Selecting the display language ....................................................... 14
2.3 Setting the measurement unit ......................................................... 14
2.4 Selecting the measuring probe ....................................................... 15
2.5 Scaling the analog display .............................................................. 15
2.5.1 In static measuring mode (standard) .............................................. 15
2.5.2 In dynamic measuring mode (max, min, max-min) ........................ 15
2.6 Connecting the measuring probe .................................................... 16
2.7 Selecting the probe type ................................................................. 16
2.8 Setting up the probe ........................................................................ 17
2.9 Switching OFF ................................................................................ 18
3. Measurement menu
3.1 Selecting the master ....................................................................... 19
3.2 Selecting the nominal value ............................................................ 20
3.3 Selecting the tolerance ................................................................... 21
3.4 Selecting the formula ...................................................................... 23
3.5 Selecting the function ...................................................................... 24
3.6 Selecting the factor ......................................................................... 25
Order no. Last modication Version
3723034 31.10.2016 Valid from rmware version 1.3
To Next Page
Loading...
Need help?
General
