Forfeiture of warranty
Service work caused by viruses that were introduced via a network connection or other data
carrier, are generally excluded from warranty services.
Storage temperatures below -10°C or above +50°C and relative humidity levels above 85%
will invalidate the warranty for the instrument.
Safety information
This measuring instrument complies with the relevant safety regulations. It was dispatched
from our production facility in a awless condition and perfect working order. However, failure
to follow the instructions given below can cause personal injury or death.
1. Before you connect up and use the measuring instrument for the rst time, please
read the accompanying documentation. Follow the safety precautions detailed in the
operating instructions.
2. Keep the documentation close to the measuring instrument ready for quick reference.
3. Follow all safety precautions, accident prevention regulations and internal company rules
and guidelines. If necessary you should request further information from your company
safety ofcer.
4. Before connecting up this measuring instrument, please check the local mains supply
voltage to ensure that it is within the working range of the AC adaptor (100 V - 240 V,
50 Hz - 60 Hz). If they do not match, this measuring instrument must not be connected
under any circumstances!
5. The instrument may only be connected to a grounded power socket which complies with
the regulations of the local power supply company. This also applies to any extension
cables that are used.
6. Only use original and intact AC adapters.
7. When connecting inductive probes ensure that the plugs are rmly screwed onto the
connection sockets.
8. Do not drop the instrument and make sure it is positioned securely.
9. Do not operate the instrument in areas where there is a risk of explosion and do not
expose it to direct sunlight!
10. Do not clean the membrane keypad with solvent-based cleaning agents.
11. Before opening the housing, disconnect the power supply.
12. The test and measuring equipment, for which the Millimar is used, are subject to
inspection equipment monitoring. For this reason, regular inspection equipment
monitoring performed by either the user or Mahr Service must ensure compliance to the
specied error limits for the test and measuring equipment.
!
To Next Page
Loading...
Need help?
General
