mainero 2240 - Tractor

13
TRACTOR
• Power:
- 60 kW (80 CV ) - Minimum
• Power Take-off:
- Normal splined shaft Ø 35 mm - 6 spli-
nes - SAE 1 3/8”.
- Nominal Regime: 540 RPM (IRAM
8003)
• Hydraulic Circuit:
- 1 double effect Hydraulic Circuit (two
outlets)
- Minimum Pressure: 11768 kPa (117.68
bar) (120 Kg/cm
2
).
- Minimum Flow: 25 l/min.
- Center System “OPEN” or “CLOSED”
(it use is indistinct).
- Female hydraulic coupling of 1/2”.
DRAW BAR
Register at 360 mm or 14” Fig. 5, mea-
sured from the splined shaft edge of the
PTO to the hole where it´s localized the
hitch pin.
If dimension is not adequate, correct from
the draw bar.
HITCH PINS
Utilize hitch pins “A” Fig. 6 with their co-
rresponding safety clip “B”:
• Maximum Diameter: 32 mm
• Minimum Diameter: 30 mm
For those tractors at which it is not posible
to reach this dimension, see “PTO Shaft”.
FIG.5
FIG.6
FIG.4
SLING
She should cut the ties that the Bagger
xes to the means of transport.
Use a metallic support with chains or ta-
pes like sample the Fig. 4 (not provided),
to take the Bagger without hopper.
Use half of elevation “F” with a superior
capacity to the 2000 kgs.
Maintain far away people when realize
this task. Avoid accidents.
Down the machine to oor, place in secure
position and proceed to the armed. (Hop-
per installation, working position, etc.)
Use the elements (tools, apparels, etc)
appropriate for this task.
Never sling the machine with the ins-
talled bolted or to elevate the machine
taking it from the bolted.