31
BAG CLOUSURE
The bag clousure for “Start” can be done
in the following ways:
1. Use 1” x 4” of 2.5 or 3 m (8 or 10 ft)
long wood tables, with an inner slot like
shows Fig. 47, fold the endsfrom outsi-
de to the center and down, being left
on the ground a bag width smaller than
the table slot.
Roll downwards three of four turns and
put a staple in each end of the table to
attach it to the groung Fig. 47
2. Use 1” x 4” of 2.5 or 3 m (8 or 10 ft)
long wood tables, with an inner slot like
shows Fig. 48, fold the ends from out-
side to the center and down and roll it
downwards the bag 3 or 4 turns. When
it is well sealed, put a table above and
other below Fig. 48, and put nails or
bolts every 300 or 400 mm (1ft), to
acieve a good sealing.
3. Using a tought rope, joint the plastic
from both sides of the bag, in folds of
50 - 60 cm (1.5 - 2 ft) towards the cen-
ter and down. Get the entire bag in the
center and tie rmly with a rope al 20
30 cm ( 8-12 in) from the end Fig. 49.
Once acomplished the clousure, have
thje caution of pulling out 3m (10 ft) of
the bag backwards of the tunnel and
place the tie at the machine center
before start lling.
FIG.47
FIG.48
FIG.49
To Next Page
Loading...