Now there’s only one thing left to do: plug the 6-position cable
that comes out of your battery monitor into the PM port as
shown earlier in the chapter. Make sure that the red wire within
the cable is on the right side (as indicated by the port label).
Wrapping Up
That’s it for the GPS, compass, and battery monitor. Later in the
book, we will use the
flight controller software to confirm that
the GPS is picking up the signal that we are looking for. We will
also take a look at the settings for the battery monitor. For now,
move on to the next chapter.
106 Make: Getting Started with Drones
To Next Page
Loading...