when working on subsequent projects later in the book. We usu-
ally use a fine-tip marker or paint pen and label the motor num-
ber on the ESC lead.
Wrapping Up
At this point, you should have your speed controllers and
motors permanently mounted. Make sure everything is firmly
mounted with little risk of coming loose. Also check all soldering
in your power harness/power distribution board to make sure
nothing is loose. The connection between your motors and
speed controllers should be temporary at this point. We will
return to the motor wiring later in the book when all our compo-
nents are installed.
Power Train 77
To Next Page
Loading...