Step 1: Mount the Power Distribution
Board (PDB)
The very first thing we need to do is secure a location in our
dirty frame for the PDB. At the time we did our build, we made
our own PDB from copper-clad G-10 (see Figures 3-8 and 3-9),
but there are many small inexpensive versions on the market
that fit the need. This one fits perfectly in the middle of our dirty
frame. Start by applying a couple of small strips of double-sided
tape to the back side of the PDB (see Figure 3-10).
Figure 3-8. Our DIY power distribution board cut from copper-
clad G10.
Power Train 53
To Next Page
Loading...