a storage setting you can use that brings it down to a nice 3.8
volts per cell. This will greatly increase the life of your batteries.
Step-by-Step Build Instructions
For this portion of the build, you will need (see Figure 3-7):
• Soldering iron and solder
•
Helping Hands or some other clamping system
•
Heat gun
•
12 pairs (male and female) of 2-mm bullet connectors
•
Several inches of 1/8-inch heat shrink
•
Wire cutters/strippers
•
Allen wrenches
•
Small zip ties
•
Double-sided foam tape
•
Scissors
Figure 3-7. The materials list for this chapter is pretty serious!
52 Make: Getting Started with Drones
To Next Page