6-9
iv. Discard the removed sleeve.
NOTE: DO NOT attempt to reinstall the probe’s protective sleeve by hand. Doing so may cause
injury to the user.
PRECAUTION: Discard the probe, sleeve (if used), and vacuum tubing in the appropriate
container(s) after use.
f. If additional sampling is planned, follow Steps 6-9 in Chapter 3: Initial Installation and Getting
Started, Setup to install a new probe and sleeve onto the holster.
Disconnecting Input Devices
a. Disconnect the remote footswitch or remote keypad from the control module’s remote device
connection port.
NOTE: Input devices may be disconnected from the control module at any time.
b. Clean and/or disinfect the input device for later use as described in Chapter 7: Cleaning and
Disinfection.
Disconnecting the Vacuum Canister
a. Disconnect the control module’s flexible vacuum source tube from the center port of the lid.
b. Close all ports at the top of the vacuum canister.
c. Discard the vacuum canister in the appropriate container after use.
To Next Page
Loading...