C1-MOVEMENT WARNINGS
DRIVER PRESENCE WARNING
(Depending on legislation in force in the country)
This alert, accompanied by an audible signal, indicates that the operator is
not seated correctly in the seat (
-FORWARD/NEUTRAL/REVERSE GEAR
SELECTOR).
SEAT BELT PRESENCE WARNING
This alert, accompanied by an audible signal, indicates that the operator has
not done up the seat belt (-FORWARD/NEUTRAL/REVERSE GEAR SELECTOR).
PARKING BRAKE WARNING
This alert, accompanied by an audible signal, indicates that the parking brake is on when the operator requests
movement of the machine.
MACHINE MOVEMENT WARNING
This alert, accompanied by an audible signal, indicates that the gear selector is not in neutral when the machine
is started.
C2-ENGINE FAULTS
These faults appear on the screen in 4 zones.
NOTE: Additional alerts other than engine faults can appear simultaneously.
Zone Fault Status Designation
1
z
MACHINE SHUTDOWN (in safe conditions)
"particulate filter regeneration status and management" table
z
ENGINE FAULTS
"particulate filter regeneration status and management" table
z
HIGH EXHAUST GAS TEMPERATURE (Regeneration of the particulate filter in progress)
"particulate filter regeneration status and management" table
2
z
"STATIONARY MACHINE" PARTICULATE FILTER REGENERATION (in progress)
"particulate filter regeneration status and management" table
}
"STATIONARY MACHINE" PARTICULATE FILTER REGENERATION (required)
"particulate filter regeneration status and management" table
z
"STATIONARY MACHINE" PARTICULATE FILTER REGENERATION (dealer)
"particulate filter regeneration status and management" table
3
z
POLLUTION CONTROL SYSTEM FAULT
See below
4
z
DISABLING AUTOMATIC REGENERATION
See below
z
PARTICULATE FILTER CLOGGING
"particulate filter regeneration status and management" table
}
EXHAUST GAS RECIRCULATION SYSTEM FAULT
See below
z: Fixed
}: Flashing
2 - 35
11:02
1550.0
h
1:0
1 2
3 4
11:02
1550.0
h
1:
647866 M1 (A012021)
TMT ... K ST5 S1