Marantz SR5008/U1B - Page 59

1.7. Complete the rmware updating
(1) Click the "Update" button.
(2) Whenwritingofthermwareiscompleted,thepowerofAVreceiverturnsonautomaticallyandyoucanseethe
"Update completed" message.
After replacing U2603, always update the Firmware. After the update has been completed, initialize network.(<57page)
(3) Ifyoucan’tcompletethermwareupdate,pleaseretrythermwareupdatefrom"1.3. Turn on the AV receiver".
1.8. Notice:
Pleasekeepthefollowingnoticeforrmwareupdate.
(a) Keep the PC environment
(b) Avoid the communication cable from the electrical noise source.
(e.g.telephonecable,ACline,auorescentlight)
(c) Don’t remove cable during update.
(d) Don’t turn off the power during update.
(e) Don’t run other PC application during update.
(f) Stop the resident program on PC (Virus checker and System check utility, etc.)
(g) Stop the screen saver on PC.
(h) Stop the power save ability on PC.
(i) In case of laptop PC, Use the AC adaptor.
Conrmingthermware’snumberafterupgraded
Afterupdatingthermware,checktheversion.Referto"1. μcom/DSP Version display mode" (24 page ).
XXXXXXX
XXXXXXXX
59
www.audiodna.sk