Marantz SR7008 - Amp Assign; Manual Setup

192
Appendix
TipsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Settings
Manual Setup
Perform when setting the speakers manually or when changing settings
made in Audyssey® Setup.
•If you change the speaker settings after performing Audyssey® Setup,
it will not be possible to select Audyssey MultEQ® XT32, Audyssey
Dynamic EQ® and Audyssey Dynamic Volume® (vpage 167, 168,
169).
•“Manual Setup” can be used without changing the settings. Please set
if necessary.
Amp Assign
Select power amplifier usage method.
2 Assign Mode
Set the assignment mode.
9.1ch(SB/FH/FW) (Default) : Assigns all power amplifiers within this
unit for MAIN ZONE.
7.1ch + ZONE2 : Setting to assign the unit’s built-in power amplifier for
ZONE2 and output the audio in stereo.
5.1ch + ZONE2/3 : Setting to assign the unit’s built-in power amplifier
for ZONE2 and ZONE3 and output the audio in
stereo.
7.1ch(Bi-Amp) : Setting to assign the unit’s built-in power amplifier
for front speaker bi-amp connections and output the
audio in stereo.
5.1ch(Bi-Amp) + ZONE2 : Settings to use the front speakers via the
bi-amp connection and assign the internal
power amp for ZONE2 to output stereo
audio.
7.1ch + Front B : Setting to use the second set of front speakers for
playback. You can switch the speaker to be used as
the “Front Speaker” (vpage198) between Front
speaker A and B.