Marantz SR7008 - Page 215

215
Appendix
TipsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Settings
2 Experimenting with preset codes one by one
for registration
1
Switch the power on of the device for which you want
to set the preset code.
2
Press and hold down the input source select button
that you want to register the preset code to and SET
until “PRSET” indicator on the remote control display is
flashing, then release.
3
Aim the remote control at the appliance and slowly
alternate between pressing CH/PAGE d and DEVICE X
for the appliance.
The preset code is shown in the remote control display.
4
Stop when the appliance turns o.
5
Press ENTER once to lock in the code.
%
•Some manufacturers use more than one type of remote control code. Preset codes
to change the number and verify correct operation.
•If the AV device is not a Marantz device, or if the device does not operate even
when the preset code is registered, use the learning function. Remote codes
for dierent devices can be remembered for use by the Marantz remote control
included with this device.
NOTE
•Depending on the model and year of manufacture of your device, some buttons
may not operate.