10
15 TROUBLESHOOTING
GLASS CERAMIC HOB
The radiant hotplate does not heat
Possible causes:
• Check the fuses.
• Power supply main switch disconnected.
• Insucient voltage or incorrect electric connection of the ap-
pliance.
• Defective energy regulator.
• Element defective or not properly connected (burnt internal
heating element).
Heating cannot be adjusted
Possible causes:
• Temperature thermostat defective.
HOTPLATE COOKER HOB BURNER
The hotplate does not heat.
Possible causes:
• Check the fuses.
• Power supply main switch disconnected.
• Insucient voltage or incorrect electric connection of the ap-
pliance.
• Temperature thermostat defective.
• Element defective or not properly connected (burnt internal
heating element).
Heating cannot be adjusted
Possible causes:
• Temperature thermostat defective.
ELECTRIC OVEN
The appliance does not heat.
Possible causes:
• Temperature thermostat defective.
• Heating elements defective.
• Safety thermostat tripped.
Heating cannot be adjusted
Possible causes:
• Temperature thermostat defective.
VERSIONS CON FAN OVEN
The oven fan motor is not working.
Possible causes:
• The oven fan motor is faulty.
• The fan motor area thermal fuse is faulty.
16 REPLACING COMPONENTS
REMINDERS FOR REPLACING COMPONENTS.
• Disconnect the appliance electrical power supply, if present,
before proceeding with any operation.
• After replacing a gas system component, check for gas leaks
at connection points.
• After replacing an electrical system component, check it is
correctly wired.
• When replacing the radiant hotplates, handle and re-assem-
ble parts with the utmost care.
GLASS CERAMIC HOB
Replacing the radiant hotplates
• Remove the control panel.
• Remove the tray by tilting it downwards and pulling it out.
• Replace the faulty component.
• Re-assemble all parts. For assembly, proceed in reverse order.
Replacing the thermostat
• Remove the control panel.
• Remove the tray by tilting it downwards and pulling it out.
• Remove the bulb from its seat and replace the faulty part.
• Re-assemble all parts. For assembly, proceed in reverse order.
Glass ceramic hob
• In the event the glass ceramic hob is broken, contact our
company to have it replaced.
HOTPLATE COOKER HOB BURNER
Replacing the radiant hotplates
• Remove the control panel.
• Remove the tray by tilting it downwards and pulling it out.
• Replace the faulty component.
• Re-assemble all parts. For assembly, proceed in reverse order.
Replacing the thermostat
• Remove the control panel.
• Remove the tray by tilting it downwards and pulling it out.
• Remove the bulb from its seat and replace the faulty part.
• Re-assemble all parts. For assembly, proceed in reverse order.
ELECTRIC OVEN
Replacing the knob and indicator light.
• Remove the control panel.
• Remove and replace the component.
• Re-assemble all parts. For assembly, proceed in reverse order.
Replacing the working thermostat and safety thermostat.
• Remove the control panel.
• Remove the bulb from its seat on the side of the oven.
• Remove and replace the component.
• Re-assemble all parts. For assembly, proceed in reverse order.
Replacing the heating element
• Remove the oven oor (only for lower heating elements).
• Undo the screw securing the element to the oven and pull the
element out by approx. 10 cm.
• Remove and replace the component.
• Re-assemble all parts. For assembly, proceed in reverse order.
To Next Page
Loading...