12 Martin
®
MAC One User Manual Rev. B
• User-settable fixture ID number
• DMX mode
• Personality settings (pan/tilt, cooling, dimming curve, DMX reset, effect shortcuts, display settings,
error mode, etc.)
• Resettable and non-resettable counters
• Service settings (adjustment, calibration)
These settings can be returned to factory defaults using the control menus, via RDM or from a P3
controller.
Display sleep
The control panel display remains permanently on by default, but you can set it to enter sleep mode and
black out automatically after two, five or ten minutes with no key press.
When the display is in sleep mode, as soon as a button on the control panel is pressed, or if the fixture’s
self-diagnosis system detects an error, the display lights up again.
Activating service mode
Holding the MENU and ENTER buttons both pressed in while powering the fixture on puts the fixture into
service mode, in which pan and tilt are disabled and a SERV warning appears in the display. Service
mode removes the risk of unexpected head movement during service adjustments.
To take the fixture out of SERVICE mode, power the fixture off, then reapply power and allow the fixture to
start normally.
To Next Page
Loading...
