18 Martin
®
MAC One User Manual Rev. B
For best results, we recommend that you enable video tracking when using video as a source and disable
it (the default setting) during DMX control.
DMX reset
You can enable the DMX reset option using the onboard control panel, RDM or P3.
DMX RESET lets you decide whether it should be possible to send a reset command to the fixture via
DMX. Disabling DMX Reset makes it impossible to reset a fixture accidentally (an accidental reset could
be a major disruption during a show).
Effect shortcuts
You can enable Effect shortcuts using the onboard control panel, RDM or P3.
EFFECT SHORTCUT determines whether the virtual color wheel takes the shortest virtual path between
two positions (shortcuts enabled), crossing the open position if necessary, or always avoids the open
position (shortcuts disabled).
Cooling mode
You can select a cooling mode using the onboard control panel, the Control/settings DMX channel, RDM
or P3.
There are five cooling fan options:
• CONSTANT FAN FULL optimizes cooling fan operation for the lowest possible temperature by setting
cooling fans to run constantly at full speed. Light output intensity is kept at its maximum, as the LEDs
operate at the coolest temperature possible.
• CONSTANT FAN MEDIUM sets cooling fans to run constantly at medium speed. Light output intensity
is reduced if necessary to prevent the fixture from exceeding its maximum operating temperature
during medium speed fan operation.
• CONSTANT FAN LOW sets cooling fans to run constantly at low speed. Light output intensity is
reduced if necessary to prevent the fixture from exceeding its maximum operating temperature during
low speed fan operation.
• CONSTANT FAN ULOW (ULTRALOW) optimizes cooling fan operation for the lowest possible noise
by setting cooling fans to run constantly at ultra-low speed. Light output intensity is reduced if
necessary to prevent the fixture from exceeding its maximum operating temperature during ultra-low
speed fan operation.
• REGULATED FANS (the default setting) adjusts cooling fan operation to balance the fixture’s noise
and light output characteristics. Cooling fans are set to the lowest speed possible and then increased
as fixture operating temperature rises. If the fixture reaches maximum operating temperature and full-
speed fan operation is not enough to control fixture temperature, light output intensity is limited to keep
the fixture within its operating temperature range.
Display options
The following options for the fixture’s onboard control panel display are available using the onboard
control panel, RDM or P3:
• DISPLAY SLEEP sets the fixture display to black out a certain period after the last key press on the
fixture’s control panel. If ERROR MODE (see below) is set to NORMAL, the display will light up again if
the fixtures detects and error.
• DISPLAY INTENSITY lets you adjust the brightness of the display backlighting by setting the intensity
to a level from 0% to 100%.
• DISPLAY ROTATION rotates the display manually through 180° so that it can be read easily no matter
how the fixture is oriented.
• DISPLAY CONTRAST lets you adjust the contrast of the LCD display on the fixture’s integrated control
panel.
To Next Page
Loading...
