36 Martin
®
MAC One User Manual Rev. B
Error messages
Error messages indicate that a problem is present. The MAC One communicates errors as follows:
• Error messages flash in the display.
• If more than one error is detected, the fixture flashes all errors three times each.
• Errors are shown in the display regardless of display status: they override an inactive display and any
other information that the display might be showing.
• If an error is present, the status LED flashes red.
The possible error messages are listed in the table below:
Backlight calibration error
Backlight temperature sensor error
Error unpacking firmware bank during/after
software upload. Fixture will continue to operate
on existing firmware. Warning message is
cleared by a successful software upload or at the
next power off/on cycle.
Beam calibration data not found.
LED driver communication error
Fixture too cold. Mechanical effects movement is
disabled until fixture has warmed up.
Pan position magnetic indexing system timeout.
Fixture is unable to correct pan position (but pan
movement will often still be possible).
Tilt position magnetic indexing system timeout.
Fixture is unable to correct tilt position (but pan
movement will often still be possible).
Zoom car position sensor timeout. Fixture is
unable to correct zoom position (but zoom
movement will often still be possible).
LED high temperature cutoff activated.
LED temperature sensor error.
LED PCB high temperature cutoff activated.
LED PCB temperature sensor error.
Impossible to communicate with a module that
should be present.
Pan position indexing system timeout.
Fixture unable to retrieve data from pan position
sensor
Pan/tilt position sensor or sensors incorrectly
adjusted.
To Next Page
Loading...
