Martin MAC One - Test Functions; Manual Control and Service

34 Martin
®
MAC One User Manual Rev. B
TEST
TEST ALL
BEAM DIMMER … TILT
Run test sequence of all functions.
To test a specific function, use
UP/DOWN buttons to scroll through
functions.
Press ENTER to pause and press again
to restart test sequence.
Press MENU button to exit test.
TEST LEDS
BEAM DIMMER ... AURA V. COLOR
WHEEL
Run test sequence of LEDs only.
Press MENU button to exit test
TEST EFFECTS
ZOOM … etc.
Run test sequence of effects.
To test a specific effect, use UP/DOWN
buttons to scroll through effects.
Press ENTER to pause and press again
to restart test sequence.
Press MENU button to exit test.
TEST PAN/TILT
PAN
Run test sequence of pan functions.
Press MENU button to exit test
TILT
Run test sequence of tilt functions.
Press MENU button to exit test
MANUAL CONTROL
RESET
ALL
NO
Reset fixture
YES
BEAM STROBE … BACKLIGHT P3 MIX
Scroll through effects, then manually
control an effect
SERVICE
ERROR LIST
Empty or up to 20 errors
Show all error and warning messages
stored in memory
FAN CLEAN
OFF
Run cooling fans at high speed to help
dislodge dust and debris
ON
PAN/TILT
FEEDBACK
OFF
Enable/disable pan/tilt position
feedback system
ON
CALIBRATION
ZOOM, PAN, TILT
…
Calibration range
varies depending on
effect
Scroll through effects, press ENTER to
select. Adjust position and press
ENTER to confirm.
LOAD DEFAULTS
LOAD
Load factory default calibration settings
(or the calibration settings that have
been saved with a SAVE command if
the factory defaults have been
overwritten)
SAVE
Save current custom calibration settings
as default settings.
Important! This will permanently
overwrite the factory default calibration
settings and should normally be used
by Martin Service only!