MARTINDALE ET4500 - 2 Introduction; Inspection; Description; Accessories

Martindale ET4000 / ET4500 Introduction
8
2 Introduction
2.1 Inspection
Examine the shipping carton for any sign of damage. Inspect the unit and any
accessories for damage. If there is any damage then consult your distributor
immediately.
2.2 Description
The Martindale ET4000 and ET4500 are professional multifunction hand-held test
instruments designed to perform the measurements required for testing of low voltage
a.c. electrical installations.
The following measurements and tests can be performed:
 Voltage and frequency
 Phase sequence
 Continuity tests
 Insulation resistance tests
 RCD testing
 Fault loop / RCD non trip impedance measurements
 Line impedance and voltage drop
 Earth resistance tests (ET4500 only)
The graphic display with backlight provides a clear view of results, indications,
measurement parameters and messages. Two LED PASS/FAIL indicators are placed at
the sides of the LCD.
2.3 Accessories
2.3.1 Supplied with the ET4000
 Soft carrying bag
 Soft carrying neck belt
 Set of carrying straps
 TL180 - test probe
 TL207 - 13A plug to 3x4mm connector mains
 TL36 - test lead set
 RS232 - PS/2 cable (only used for firmware upgrade)
 6 x 1.5V AA alkaline batteries
 CD containing full instruction manual and ET-link PC software
(ET-link PC software is only useable with the ET4500)
 Short instruction manual
 Verification certificate