CombiMaster 120V Series –
User and Installation Manual
1.3 Location
1. COMBIMASTER INVERTER/ CHARGER LOCATION
i. Locate the CombiMaster Inverter/Charger away from battery in a separate, well-ventilated
compartment.*
ii. Never place the CombiMaster Inverter/Charger directly above battery; gases from battery will
corrode and damage the CombiMaster Inverter/Charger.*
iii. Never allow battery acid to drip on the CombiMaster Inverter/Charger when reading gravity or
filling battery.*
iv. Do not operate the CombiMaster Inverter/Charger in a closed-in area or restrict ventilation in any
way. To reduce risk of fire hazard, do not cover or obstruct the ventilation openings.
* This restriction does not apply to Li-ion batteries.
1.4 Connections
1. DC CONNECTION PRECAUTIONS
i. Connect and disconnect DC output connections only after setting any switches of the
CombiMaster Inverter/Charger to off position and removing AC connections or opening AC
disconnect switch.
ii. Short circuiting or reversing polarity will lead to serious damage to batteries, the CombiMaster
Inverter/Charger, wiring as well as accessories. Fuses cannot prevent damage caused by
reversed polarity and the warranty will be void.
2. EXTERNAL CONNECTIONS TO CombiMaster Inverter/Charger SHALL COMPLY WITH THE
UNITED STATES COAST GUARD ELECTRICAL REGULATIONS (33CFR183, SUB PART I).
3. GROUNDING INSTRUCTIONS – The CombiMaster Inverter/Charger should be connected to a
grounded, metal, permanent wiring system; or an equipment-grounding conductor should be run
with circuit conductors and connected to equipment-grounding terminal or lead on unit. Connections
to the CombiMaster Inverter/Charger should comply with all local codes and ordinances.
1.5 Warning regarding life support applications
Mastervolt products are not designed to be used as component of medical equipment, unless
negotiated in the form of a written agreement between customer and/or manufacturer and Mastervolt.
Such agreement will require the equipment manufacturer either to contract additional reliability testing
of the Mastervolt parts and/or to commit to undertake such testing as a part of the manufacturing
process. Furthermore, the manufacturer must agree to indemnify and not hold Mastervolt responsible
for any claims arising from the use of the Mastervolt parts in the life support equipment.
To Next Page
Loading...
Need help?
General
